How to Grow and Care for Italian Cypress

Tall, columnar Italian cypress (Cupressus sempervirens), also known as Mediterranean cypress, is said to look like a bird's feather or exclamation point, which makes it stand out and up, especially when several are planted side by side.

Italian cypress grows to an average 50 feet tall and spreads just 4 to 5 feet, narrowing to a point at the crown. Foliage is evergreen with sprays of dark gray-green needles on short, upright branches. It does not flower but produces glossy, round, brown or copper-colored seed cones in autumn.

This evergreen lives up to a 150 years in the urban landscape and a thousand years in its native climate. Several shorter cultivars offer greater versatility for homeowners, growing from 10 to 30 feet tall and one to three feet wide. Given the right climate, this is a fairly easy tree to grow.

Italian Cypress Care

Italian cypress is a low-maintenance tree. Here are the main care requirements for Italian cypress:

• Plant Italian cypress somewhere where it will receive at least four hours of direct sunlight per day.
• Prepare well-draining soil.
• Water young trees as they are becoming established. There is no need to provide supplemntal water for older trees.
• Protect Italian cypress trees if the temperatures drop below 10 degrees by moving potted plants or covering in-ground plants.
• Prune dead or dying branches in late winter.

Light

Plant Italian cypress in full to partial sun with at least four to six hours of even sunlight daily. Growing too close to a fence or building results in uneven or stunted foliage on one side. A small amount of shade is tolerated, but too much can lead to a scraggly, unattractive appearance.

Soil

This evergreen adapts to a wide range of soil types, as long as they drain well. Plant in sandy loam with a pH of 5.5 to 7.5 if possible.

Water

Italian cypress trees prefer to grow in dry conditions. Water young trees regularly until established. Mature trees are drought-resistant and usually thrive with average rainfall amounts in their growing zones. Overwatering can lead to root rot, causing leaves and branches to turn yellow and die back. Water at the base of the tree to prevent fungal infections.

Temperature and Humidity

Hot, dry climates are preferred. This tree can tolerate temperatures as high as 125 degrees for short periods of time, if kept hydrated. Provide winter protection when temperatures dip to 10 degrees or below. Humidity associated with high temperatures is tolerated better that cold, wet air.

Fertilizer

Only apply fertilizer if you have a soil deficiency and have tested for it.

Types of Italian Cypress

• C. sempervirens 'Glauca (Blue)': a fast-growing, dense variety with-blue green foliage. Also called pencil pine, reaches 40 to 60 feet in height with a 5 to 10 foot spread.
• C. sempervirens 'Green Pencil': the tallest variety at up to 115 feet tall with a very narrow spread of 3 feet. Foliage is gray-green.
• C. sempervirens 'Swane’s Golden': a dwarf cultivar producing new foliage in a golden yellow color. This type grows slowly to 20 feet tall with a spread of 3 feet.
• C. sempervirens 'Swane’s Variegated': a narrow dwarf variety growing 10 feet tall and just 1 foot wide. Foliage is dark green liberally marked with patches of yellow.
• C. sempervirens 'Tiny Tower': a dwarf variety growing to 30 feet tall and 3 feet wide. Lush blue-green foliage.

Pruning

Cut back foliage in late winter to promote even, lush growth, removing dead or dying branches along the way. This tree is grown for its distinct appearance, so trimming helps achieve and maintain a desired shape.

Methods are similar to pruning a hedge. When the tree reaches a desired height, it can be topped by removing 6 inches of the crown. Flat-topping halts upward growth and increases width of the spread.

Propagating

The best way to propagate Italian cypress is by taking cuttings in winter. You need a hand pruner or snipper, potting medium, a 6-inch pot with drainage holes, and a plastic covering.

1. Use the pruner to remove stems from a young trees or from the lowest branches or larger tree, and remove needles from the bottom four inches of the stem/cutting.
2. Fill a 6-inch pot with a moistened mix of potting soil, sand, and perlite.
3. Insert the bottom part of the cutting into the soil, making sure attached needles clear the soil line, and water well.
4. Place the pot in a plastic bag and set it in bright, indirect light with temperatures between 60 and 70 degrees. Keep the potting medium moist.
5. Roots should begin to develop in five to six weeks. Check by gently pulling on the cutting.
6. Continue to grow seedlings in pots for one year before transplanting.

How to Grow Italian Cypress from Seed

Seeds can be purchased or collected from cones. They fall easily from the cone when mature and require stratification. Sow seed in pots in winter and keep them in an outdoor location, or bag seed with a small amount of moist sawdust and refrigerate for three to four weeks. You'll need seeds, potting mix, compost and a flat or small pots. When you're ready to plant, follow these steps:

1. Moisten a mix of potting medium and compost.
2. Use pots with drainage holes or poke several holes in the bottom of a flat. Fill with potting mix.
3. Make a slight depression about 1/4 inch deep for each seed. Cover loosely with mix.
4. Place in bright, indirect light with temperatures between 65 and 70 degrees F.
5. Keep moist by misting or watering with a rose spout or spray setting on your hose nozzle. Do not let containers dry out.
6. Germination occurs in one to two months. When seedlings are sturdy enough to handle, pot up into 6 inch pots and continue growing out for one year before planting in the garden.
7. If grown indoors, make sure to harden off seedlings.

Potting and Repotting

Italian cypress can be grown in pots, but you should be prepared for extra maintenance to keep them looking good. Water container-grown trees regularly and fertilize with an NPK slightly higher in nitrogen, once in spring and mid-summer.

Starting out with a nursery grown tree, pot it up into a container at least 2 inches larger than the one it's in. Choose a container with plenty of drainage holes and fill it with potting soil mixed, sand, and perlite. Plant the tree at the same soil level as in its original pot.

Pot up as needed until the tree reaches the desired height. Do this in fall and winter when the tree is dormant to prevent transplant shock. To maintain height and keep roots from overcrowding, the roots should be pruned annually.

Overwintering

Italian cypress grown in USDA zones 7 to 10 do not need winter protection, unless temperatures fall to 10 degrees F. or below. Covering young, vulnerable trees can prevent frost damage. Potted Italian cypress do need some protection and can be moved to a sheltered location, as long as they continue to receive bright sunlight. Reduce watering when the tree is in dormancy.

Common Pests and Plant Diseases

This tree is fairly disease and pest free. Bagworms and spider mites can lead to unsightly webbing and defoliation. Bagworm cocoons can be handpicked. Use a strong hose spray to remove spider mites but do this early in the day to allow foliage to dry before nightfall.

Cypress canker is a fungal disease identified by long, narrow sunken spots on the trunk or branches that ooze sap. Needles turn yellow, then brown and die. Control canker by removing infected branches, sterilizing your cutting tool between each cut. Root rot also presents as foliage dieback and occurs when a tree is overwatered.

Common Problems with Italian Cypress

This is an easy care evergreen with drought tolerance, disease and pest resistance. Common problems most often relate to maintaining its size and shape.

Uneven foliage

Planted too close to a structure that blocks bright sunlight, Italian cypress develops uneven foliage with healthy, dense needles on the sunny side and straggly, thin foliage on the shaded side.

Multiple trunks

Some cultivars can develop more than one trunk. Keep an eye out for this during the first several years of rapid growth and remove any suckers growing on or near the base of the tree. Each trunk will produce branching and a crown. This results in poor air circulation and defeats the single columnar shape of the tree.

Unbalanced growth with multiple plantings

This is a problem when several trees are planted in a hedge type grouping. Not allowing enough distance between trees causes them to compete for nutrients and can lead to stunting or uneven growth. Roots are shallow and spread to the width of the tree. Leave enough room between your chosen variety to accommodate its mature width.

From: thespruce